Roland AT90S - Manual (Page 78)

76
Chapter 3 Using the Registration Buttons
The AT-90S/80S/60S allows you to store sound settings and panel settings
in the Registration buttons. The AT-90S/80S has a total of twelve
registration buttons (the AT-60S has eight), and one set of panel settings can
be registered to each button, for a total of twelve types (eight types on the
AT-60S) of panel settings. Each set of panel settings that has been stored in
a Registration button is called a “Registration.”
This provides a convenient way to change large numbers of panel settings
during a performance, or to recall a complex panel setting.
AT-90S/80S
fig.03-01
f
AT-60S
ig.03-02
Storing Registrations
fig.03-02
1.
Make all the panel settings that you wish to store.
2.
While holding down the [Write] button, press one of the
Registration buttons [1]–[12] (on the AT-60S, Registration
buttons [1]–[8]).
The panel settings will be stored in the selected Registration button.
6 Write Load
Next
2 3 4 5 7 8 9 10 11 12 1 Manual
6 Write Load
Next 2 3 4 5 7 8 1 Manual
Settings that have been
stored to Registration
buttons [1]–[12] (on the AT-
60S, Registration buttons
[1]–[8]) are remembered
even if the power is turned
off. If you wish to restore
the settings stored in the
Registration buttons to
their factory settings, use
the “Factory Reset”
operation (p. 22).
Write 2 3 5 6 4 1 Manual
With the settings of
Registration buttons [1]–
[12] (on the AT-60S,
Registration buttons [1]–
[8]) considered as one set, a
single floppy disk (2HD)
can store up to 99 sets of
data (p. 84).
For details on the settings
that are stored in a
Registration, refer to (p.
222).