Roland AT90S - Manual (Page 219)

217
Replacing the Illumination Bulbs
■ Pedal illumination (AT-90S
only)
Remove the foot lamp cover
1. Unplug the power cord from the AC outlet.
2. Insert a screwdriver vertically into the slot of the
foot lamp cover, and pull the screwdriver toward
yourself to remove the foot lamp cover.
fig.13
NOTE
When removing the foot lamp cover, do not pull the
screwdriver forcefully.
Remove/install the light bulb
1. Grasp the body of the light bulb, and while
pressing it inward, slowly turn it toward yourself
and remove it.
fig.14
2. Align the protrusions of the new light bulb with
the slots of the socket.
fig.15
3. While pressing the light bulb inward, turn it
away from yourself.
fig.16
NOTE
When installing the light bulb, turn it until it stops.
Attach the foot lamp cover
1. Position the foot lamp cover as shown in the
diagram below.
fig.17
NOTE
When attaching the foot lamp cover, be sure that the left/
right orientation is correct. If the left/right orientation is
incorrect when you insert the cover into the slot, it may be
damaged.
2. Raise the foot lamp cover until it stops.
Slot of the socket
Protrusion of the light bulb