Texas Instruments TMS320C6454 - Manual (Page 76)

www.ti.com
PRODUCT PREVIEW
4.4 Priority Allocation
TMS320C6454
Fixed-Point Digital Signal Processor
SPRS311A – APRIL 2006 – REVISED DECEMBER 2006
On the C6454 device, each of the masters (excluding the C64x+ Megamodule) are assigned a priority via
the Priority Allocation Register (PRI_ALLOC), see
Figure 4-3 . The priority is enforced when several
masters in the system are vying for the same endpoint. A value of 000b has the highest priority, while
111b has the lowest priority.
Note that the configuration SCR port on the data SCR is considered a single endpoint meaning priority will
be enforced when multiple masters try to access the configuration SCR. Priority is also enforced on the
configuration SCR side when a master (through the data SCR) tries to access the same endpoint as the
C64x+ Megamodule.
Other Master peripherals are not present in the PRI_ALLOC register as they have their own registers to
program their priorities. For more information on the default priority values in these peripheral registers,
see the device-compatible peripheral reference guides. TI recommends that these priority registers be
reprogrammed upon initial use.
31 16
Reserved
R-0000 0000 0000 0000
15 12 11 9 8 6 5 3 2 0
Reserved Reserved Reserved HOST EMAC
R-000 0 R/W-001 R-0 R/W-010 R/W-001
LEGEND: R/W = Read/Write; R = Read only; -n = value at reset
Figure 4-3. Priority Allocation Register (PRI_ALLOC)
System Interconnect 76 Submit Documentation Feedback