Toshiba FS-2600-1 - Manual (Page 138)

5. PROGRAMMING OPERATIONS EO1-11138
5-39
5.4 How to Access a Program Item
* SET * 02-06-1999 12:34
PROGRAMMING RKP MESSAGE
↓
01
02
03
04
05
06
07
08
Please input item No.
0.00
Pg up Pg dw Enter ↑ ↓
■ RKP Message Programming (Submode 30)
This programming is used to set 20 RKP messages (a maximum of 20 characters x 2 lines for each), and also
used to designate an RKP on which each message is outputted. If your printer is the TM-300, you can select a
color for each message.
CONDITION Any time outside a sale When you enter 30 and depress the [X] key,
the screen shown below will appear.
OPERATION Mode Lock: SET
Address 1: Guest Name
1 [ST]
Submode No.
30 [X] |Message No.| [NS]
1 to 20
|1st Line Message Entries| [ST]
Max. 20 characters
Initial Setting: Blank for all characters
[AT/TL]
Repeat for another message.
Guest Card Reading through the MCR
Address 1: Guest Name
2 [ST]
|2nd Line Message Entries| [ST]
Max. 20 characters
Initial Setting: Blank for all characters
Address 1: Guest Name
3 [ST]
|RKP No. of the destination| [#]
Max. 4 digits: Multiple RKPs are selectable.
(NOTE 2 below) Initial Setting: RKP No. 1
Address 1: Guest Name
4 [ST]
|Color| [#]
0: Black (Initial Setting)
1: Red
ex.) To set the following to the RKP message 1. Journal Print
• 1st Line: 20 RKP MESSAGES ARE
• 2nd Line: PROGRAMMABLE!
• Destination: 13 (RKP Nos. 1 and 3)
Mode Lock: SET
Enter 30, depress [X].
1 [NS] 1 [ST] 20 [SPACE] RKP [SPACE]
MESSAGES [SPACE] ARE [SPACE] [ST]
(2 [ST]) PROGRAMMABLE! [ST] (3 [ST])
13 [#] [AT/TL]
NOTES: 1. When you fill one whole line with all blanks, it will result in a one line space.
2. When you want to designate the RKP Nos. 1 and 3 as the destinations, enter 13, then depress
the [#] key.
P30 RKP MESSAGE
01
#01 20 RKP MESSAGES ARE
#02 PROGRAMMABLE!
#03 13
0051 17:01TM