Toshiba FS-2600-1 - Manual (Page 191)

3. PROGRAMMING OPERATIONS EO1-11138
3-3
3.2 Programming Operations Added for In-line Terminals
. . .
1 to 16
(NOTES 1 & 2 below)
Repeat for other terminals to be connected, including the Master Terminal
itself.
. . .
0 to 999999
(NOTE 2 below) * * For sequentially programming
In-line ID Nos., the In-line ID
specification can be skipped.
ex.) To set the following.
Master Terminal
ID No. 1 Register No. 3001
Satellite Terminal ID No. 3 Register No. 3002
Mode Lock: SET/RTR Declaration is ON.
69 [X]
1 [ST] 3001 [#]
3 [ST] 3002 [#]
[AT/TL]
Journal Print
Through the Keyboard
69 [X] |In-line ID No.| [ST] |Register No.| [#] [AT/TL]
P69 CONNECT REG
#01 #3001
#03
#3002
0196 01:52TM
NOTES: 1. In-line ID No.: Master Terminal ............................................ 1 (fixed)
Backup Master Terminal (if connected) ........ 2 (fixed)
Satellite Terminals ......................................... 3 to 16 (max. 14 terminals)
However, a number of the connectable terminals differs depending on your system configuration.
Refer to the chapter 1. SYSTEM CONFIGURATION of the Operator’s Guide.
2. The In-line ID No. and Register No. of each terminal to be set here must be the same as those
programmed for the terminal in In-line Terminal ID Setting (Submode 77) and Store/Register No.
Setting (no submode) in Chapter 5 in the Manager’s Guide for stand-alone level.
3. To delete an individual terminal from the Terminal Connection Table, enter 0 in place of the In-
line ID No. in the above operation pattern.
4. To delete the entire Terminal Connection Table once set, operate:
69 [X]
→
0 [AT/TL]
5. If a deleting operation (individual or entire deletion) is performed, the files occupied by the
deleted terminal(s) (such as Floating Cashier File, etc.) are canceled. Therefore, a deleting
operation should be performed only when the system is to be re-built or a terminal is to be
detached from the system.