Toshiba FS-2600-1 - Manual (Page 155)

5. PROGRAMMING OPERATIONS EO1-11138
5-56
Address 1: Destination of Output (Printer Table 1)
71 [X] 1 [NS] |Destination of Output| [ST] |Terminal ID/Port No.| [#]
Address 2: Connection Status (Printer Table 1)
2 [NS] |Destination of Output| [ST] |Connection Status| [#]
Address 3: Destination of Output (Printer Table 2)
3 [NS] |Destination of Output| [ST] |Terminal ID/Port No.| [#]
Address 4: Connection Status (Printer Table 2)
4 [NS] |Destination of Output| [ST] |Connection Status| [#]
Address 5: Printer Model
5 [NS] |Port No.| [ST] |Printer| [#]
Address 6: Transmission Speed
6 [NS] |Port No.| [ST] |Transmission Speed| [#] [AT/TL]
5.4 How to Access a Program Item
* SET * 02-06-1999 12:34
PROGRAMMING PRINTER
01 OUTPUT SIDE1
02 SIDE1 STATUS
03 OUTPUT SIDE2
04 SIDE2 STATUS
05 CONNECT PRT
06 BAUD RATE
Please input item No.
0.00
Pg up Pg dw Enter ↑ ↓
■ Printer Table Setting (Submode 71)
This programming is used to set a printer table. You can set two printer tables.
CONDITION Any time outside a sale When you enter 71 and depress the [X] key,
the screen shown below will appear.
OPERATION Mode Lock: SET
When the multiple destinations are designated
*
*
When the multiple destinations are designated
When the multiple destinations are designated
*
*
When the multiple destinations are designated
When the multiple ports are designated
*
*
When the multiple ports are designated
* Repeatable from here if each code is sequential.