Toshiba FS-2600-1 - Manual (Page 47)

9. TRANSACTION ENTRIES EO1-11138
9-21
9.32 Sale Paid in Foreign Currencies
*REG * 02-06-1999 03:04 1 1CLKendi
P1S1
No999999999999
SMITH 100.00
SMITH
100.00
TOTAL 100.00
DISP1 DISP2 DISP3 DISP4 DISP5
NOTE: If the PLU price level is programmed to each
customer, the PLU (menu item) entry will be
fixedly performed by the corresponding price
level. In this case, using the [PRICE] key to
change the level causes an error, and also the
hourly range price level is ignored if
programmed.
9.32 Sale Paid in Foreign Currencies
OPERATION
[ST] [CUR1] Amount Tendered in [CUR1] [AT/TL]
Foreign Currency |
*REG * 02-06-1999 03:04 1 1CLKendi
P1S1
SUBTL 20.00
TAX 1.60
TOTAL 21.60
CUR1 100.00
0.365*
CATEND 36.50
CHANGE 14.90
CHANGE
14.90
2 TOTAL 21.60
DISP1 DISP2 DISP3 DISP4 DISP5
NOTES: 1. The [CUR 2] to [CUR 5] keys operate
the same as [CUR 1], except that each
of these keys has its own exchange rate
programmed corresponding to each
foreign currency.
2. Multi-tendering with the same foreign
currency or Split-tendering with other
medias or foreign currencies are
possible.
3. The foreign currency keys cannot be
used to finalize Received-on-Account
payments, or Paid-out items.
Enter the amount
of the media to be
transferred.
. . .
Depress the media
key of the destination.
4. When a tendering by a foreign currency occurs after a short-tendered condition, the [ST] key will
not be mandatory.
5. A sale of zero or negative balance cannot be finalized using any of the foreign currency keys.
9.33 Media Transfer
This operation is used to change a media already paid and finalized into a different one.
OPERATION (must be operated outside a sale)
|Amount| [Source Media] [Destination Media]
[C]
. . . . . . . . . . . .
. . .
Mandatory for
a sale paid in
foreign
currencies. Displays the
equivalent value
in Foreign
Currency 1.
Display the entered
foreign currency
amount.
Displays the
domestic
currency value
equivalent to the
tendered foreign
currency. Other media keys may
be used if paid in that
media. (The media
key must be
programmed to allow
tendering in this case.)
Customer
Code