Toshiba FS-2600-1 - Manual (Page 162)

6. VERIFICATION OF PROGRAMMED DATA EO1-11138
6-1
6. VERIFICATION OF PROGRAMMED DATA
You can verify each data programmed in the preceding chapter. Two mode lock positions are available to verify
the data; SET and X. Also two ways are available to access a programmed data you want to verify; through the
operator display and through the keyboard.
6.1 How to verify a Programmed Data through the Operator Display
When you turn the mode selector key to the SET or X position, the initial screen shown below will appear.
SET Mode X Mode
6.1 How to verify a Programmed Data through the Operator Display
* SET * 02-06-1999 03:04
1 PROGRAMMING
2 PROGRAM READ
3 PROGRAM DLL
Please select operation by Enter key.
0.00
TOTAL 0.00
Pg up Pg dw Enter › fl
*X/GTX* 02-06-1999 03:04
1 X
2 GTX
3 PROGRAM READ
4 E-JOURNAL
5 OTHERS
Please select operation by Enter key.
0.00
TOTAL 0.00
COMB1 COMB2 COMB3 EJ fl
A way to access an item you want to verify is the same as that described in the section 4.1.1 How to Access a
Report Item through the Operator Display (on page 4-1 in the manager’s guide) or 5.4.1 How to Access a
Program Item through the Operator Display (on page 5-5 in the manager’s guide).
However, when you select “104 PLU”, the register will ask you which to choose “NORMAL” or “SIMPLE” as
follows.
*X/GTX* 02-06-1999 12:34
PROGRAM READ PLU
1 NORMAL
2 SIMPLE
Please select operation by Enter key.
0.00
Pg up Pg dw Enter › fl
• Normal Verification .............. You can verify all the programmed data of a PLU table.
• Simple Verification .............. You can verify the following data of a PLU table.
(PLU code, PLU name, tax status, link department, 1st preset price)
NOTES: 1. You can verify the following data in the address “100 MISC”.
(Preset rates for the [%], [SI/TL], [CUR] keys, tax table)
2. Addresses to verify time, date, PLU stock are not provided.