Toshiba FS-2600-1 - Manual (Page 192)

3. PROGRAMMING OPERATIONS EO1-11138
3-4
3.2.2 Terminal ID Setting (Submode 77)
This submode is available for in-line terminals (including the master and backup master terminals) . It must be
operated separately on each terminal since the Terminal ID should vary from terminal to terminal. The data set in
this submode is used as the in-line address of the terminal for in-line service operations.
CONDITION Any time outside a sale
OPERATION Mode Lock: SET and RTR Declaration is ON (for the Master Terminal)
Mode Lock: SET (for other terminals)
(Use the SET Mode Keyboard Sheet after depressing the [RTR] key on the REG Mode
Keyboard Sheet.)
Through the Operator Display
Select “1 PROGRAMMING”. Select “77 INLINE ID”.
3.2 Programming Operations Added for In-line Terminals
* SET * 02-06-1999 03:04
RTR
1 PROGRAMMING
2 PROGRAM READ
3 PROGRAM DLL
Please select operation by Enter key.
0.00
TOTAL 0.00
Pg up Pg dw Enter ↑ ↓
* SET * 02-06-1999 03:04
PROGRAMMING
68 PC COMM T/M DESIGN
69 CONNECT REG
70 INLINE COMM
71 PRINTER
73 PRICE CHG
77 INLINE ID
78 LOGO
TAX TABLE
Please select operation by Enter key.
0.00
Pg up Pg dw Enter ↑ ↓
→
1: Master
2: Backup Master
3 to 16: Satellites
ex.) To assign Terminal ID No. 4 to a satellite terminal of the in-line system:
Mode Lock: SET
77 [X] 4 [AT/TL]
Journal Print
Through the Keyboard
77 [X] |Terminal ID No.| [AT/TL]
12-25-1999 SAT #3001
P77 INLINE ID
INLINE ID 04
0196 01:52TM
NOTE: Be certain not to set the same terminal ID No. to terminals on the in-line system.
If terminals with the same ID No. exist on the in-line system, malfunction may occur.