Toshiba FS-2600-1 - Manual (Page 163)

6. VERIFICATION OF PROGRAMMED DATA EO1-11138
6-2
6.2 How to verify a Programmed Data through the Keyboard
6.2 How to verify a Programmed Data through the Keyboard
You can directly access an item you want to verify through a key operation on the keyboard while the mode lock
position is in “SET” or “X”.
■ To read out the data of programming operations with a Submode No., first enter “1,” then each Submode No.,
and finally depress the [AT/TL] key.
For example, to read the programmed data entered in Submode 1 (Store Name/Message, Commercial
Message, Footer Logo Message Programming), operate:
1 0 1 [AT/TL]
Submode No. (In case of a 1-digit number, add a “0” on top to be a 2-digit number.)
Always attach “1” to the Program Submode No. for reading data.
NOTE: Key operations to verify time, date, PLU stock are not provided.
■ To verify the data of the address “100 MISC”:
1 0 0 [AT/TL]
■ To designate a zone for the PLU table verification:
1 0 4 [ST] Zone-start [X] Zone-end [PLU]
PLU Code PLU Code |
■ To verify a PLU table data by “Simple” format:
1 0 4 [PLU]
NOTE: To verify the PLU preset-code keys programmed on ECR Keyboard phase Nos. 2 to 5:
127 [ST] 2 to 5 [AT/TL]