Toro Sand Pro 5020 - Manual (Page 153)

9. If the wheel hub needs replacing, remove hydraulic
motor from hydraulic lines, and remove hub from motor
(see Front Wheel Removal in Chapter 4 – Hydraulic
Systems).
Installation (Fig. 7)
1. If the wheel hub was removed from the hydraulic
motor, install hub to motor, and install hydraulic motor to
hydraulic lines (see Front Wheel Installation in Chapter
4 – Hydraulic Systems).
2. Position hydraulic motor and hub to the front fork.
3. Install spindle to drive studs and wheel hub. Insert
spindle and drive studs through wheel. Make sure valve
stem and hydraulic motor are on the opposite sides of
the wheel.
4. Secure lug nuts to drive studs. Torque nuts from 45
to 55 ft–lb (6.2 to 7.6 kg–m).
5. Slide flangette and bearing assembly onto the
spindle shaft so the locking collar faces the wheel.
6. Position hydraulic motor, wheel, and flangettes to
the front fork.
7. Lower front fork slowly. Make sure flangettes and
front wheel motor fit snugly into the fork.
A. Secure flangettes to the fork with cap screws,
bearing tab, and locknuts.
B. Secure hydraulic motor to the front fork with
socket head screws and lock nuts.
8. Lower fork completely. Make sure flangette and hy-
draulic motor are positioned correctly into the fork. Tight-
en fasteners properly.
9. Apply Loctite 242 or equivalent to both set screws.
Install set screws to locking collar. Torque set screws
from 65 to 80 in–lb (74.9 to 92.2 kg–cm).
Sand Pro 2020/3020/5020 Page 6 – 9 Wheels, Brakes,and Miscellaneous
Whells, Brakes,
and Miscellaneous