Toro Sand Pro 5020 - Manual (Page 34)

Remote Air Cleaner (SP 5020)
Remote Air Cleaner Removal
1. Park machine on a level surface, lower attachment,
stop the engine, engage parking brake, and remove the
key from the ignition switch.
2. Loosen hose clamp. Remove air cleaner hose from
the air cleaner body.
3. Remove both lock nuts, flat washers, and cap
screws securing the mounting band to the right fender.
4. Unlatch and remove cover from air cleaner body.
Separate body from the mounting band. Make sure not
1
5
2
4
3
Figure 22
to drop the filter element.
1. Body 4. Latch
2. Cap screw & flat washer 5. Cover
Remote Air Cleaner Installation
3. Mounting band
1. Insert air cleaner body through the mounting band.
Make sure filter element is inside the body. Install and
latch cover to the air cleaner body.
2. Secure mounting band and air cleaner to the front
shield with both cap screws, flat washers, and lock nuts.
3. Secure air hose to the air cleaner with hose clamp.
Engine Page 3 – 14 Sand Pro 2020/3020/5020