Toro Sand Pro 5020 - Manual (Page 151)

Installation (Fig. 6) 4. Secure bearing flanges to the front fork with car-
1. Position front axle and drive studs through the
wheel rim. Secure axle to rim with lug nuts to studs.
Torque nuts from 45 to 55 ft–lb (6.2 to 7.6 kg–m).
2. Place bearing between two bearing flanges. Slide
assembly onto axle with the locking collar facing away
from the wheel. Repeat with remaining bearing and
flanges on the other end of the axle.
3. Position wheel to the front fork. Make sure bearing
flanges are placed inside the fork.
riage bolts, lock washers, and hex nuts.
5. Rotate both bearing lock collars in the direction of
normal forward wheel rotation . Place drift punch into the
blind whole of the locking collar. Strike punch sharply
with a hammer in the direction of shaft rotation to lock the
collar. Repeat with other collar.
6. Apply Loctite 242 or equivalent to both set screws.
Secure locking collars with set screws. Torque set
screws from 65 to 80 in–lb (74.9 to 92.2 kg–cm).
7. Lower front wheel to ground.
Sand Pro 2020/3020/5020 Page 6 – 7 Wheels, Brakes,and Miscellaneous
Whells, Brakes,
and Miscellaneous