Toro Sand Pro 5020 - Manual (Page 8)

Jacking Instructions
Figure 1
Use the following positions when jacking up the ma-
chine:
Jacking the Front End
1. On the SP 2020/3020, jack from below the front
cross support that is above the retaining strip for the rub-
ber shield (Fig. 1).
2. On the SP 5020, jack from below the front cross
Figure 2
support tube on the bottom of the frame (Fig. 2).
CAUTION
forming other service, use correct blocks,
hoists, and jacks. Make sure machine is
parked on a solid level floor such as a concrete
attachments that may interfere with the safe
and proper raising of the machine. Always
chock or block wheels. Used jack stands or
solid wood blocks to support the raised ma-
chine. If the machine is not properly supported
by blocks or jack stands, the machine may
move or fall, which may result in personal inju-
When changing attachments, tires, or per-
floor. Prior to raising the machine, remove any
ry.
Jacking the Rear End
1. On the SP 2020/3020, jack from below the square
tube of the frame (Fig. 3).
2. On the SP 5020, jack from below the square tube of
the frame (Fig. 3).
Figure 3
Figure 4
Safety Page 1 – 4 Sand Pro 2020/3020/5020