Toro Sand Pro 5020 - Manual (Page 32)

Choke Control Installation
1. On the SP 2020/3020 insert choke cable and control
through the dash panel. Secure choke control to the
panel with lock washer and hex nut (Fig. 10).
2. On the SP 5020, secure choke control to the dash
panel or right fender with both cap screws and lock nuts.
Install knob to the choke control lever (Fig. 10).
3. Connect choke cable to the choke pivot lever. At-
tach cable to engine with clamp. Make sure not to tighten
cap screw securing clamp and cable to engine (Fig. 16).
4. Remove any covering protecting the carburetor in-
let. Install air cleaner base carefully to carburetor. Make
sure not to damage carburetor gasket while instal-
ling base (Fig. 15).
NOTE: Newer engine models will have a different car-
buretor shield that has five hex head flange screws se-
curing the shield and air cleaner base to the carburetor.
5. Secure air cleaner base and carburetor shield to the
carburetor with two cap screws and three hex head
flange screws (Fig. 15).
Figure 16
1
2
3
4
1. Carburetor 3. Clamp
2. Choke cable 4. Choke pivot lever
6. Install air cleaner element and cover plate to the air
cleaner base. Secure air cleaner cover to air cleaner.
Secure air hose to air cleaner cover. (Fig. 14).
7. Position hood to the dash panel and front shield. Se-
cure hood to front shield with three hex flange head
screws (Fig. 11). Secure dash panel to hood with four
cap screws (Fig. 12).
8. Adjust choke control (see Adjust Choke Control).
Install cover over the engine.
Replace Fuel Filter
The fuel filter on the SP 2020/3020 can be accessed
from the rear of the machine. It is located just left of the
hydrostat (Fig. 17).The fuel filter on the SP 5020 can be
accessed by pivoting up the seat up. It is located just for-
ward and right of the engine (Fig. 18).
An in–line filter is incorporated into the fuel line. Change
filter every 800 hours. Use the following procedure when
replacement becomes necessary:
1. Close fuel shutoff valve.
CAUTION
Since gasoline is highly flammable, drain it out-
doors and make sure engine is cool to prevent a
may have spilled. Do not drain gasoline near any
open flame or where gasoline fumes may be ig-
or a pipe when handling gasoline.
potential fire hazard. Wipe up any gasoline that
nited by a spark. Do not smoke a cigar, cigarette,
2. Clamp both fuel hoses connected to the fuel filter so
gasoline cannot drain when hoses are removed. Loosen
hose clamps. Pull fuel hoses off the filter.
3. Secure new filter to hoses with hose clamps. Make
sure arrow on the side of filter points toward the carbure-
tor. Remove clamps that were used to prevent drainage.
1
1
3
2
Figure 17
1. Fuel hose 3. Fuel filter
2. Hose clamp
2
2
1
1
3
Figure 18
1. Fuel hose 3. Fuel filter
2. Hose clamp
Engine Page 3 – 12 Sand Pro 2020/3020/5020