Toro Sand Pro 5020 - Manual (Page 157)

Brake Linkages (SP 5020)
30
29
31
28
26
27
1
2
3
4
5
6
7
8
9
10
16
17
18
19
20
21
22
23
24
13
14
15
20
21
17
4
25
32
11/12
RIGHT
FRONT
Figure 12
1. Curved washer 12. Right bearing bracket 23. Cap screw
2. Lever bracket 13. Washer head screw 24. Spacer
3. Lock nut 14. Flat washer 25. Hourmeter bracket
4. Lock nut 15. Cotter pin 26. Cotter pin
5. Clevis pin 16. Traverse rod 27. Adjustment rod
6. Lock nut 17. Cotter Pin 28. Jam nut
7. Side flange bearing 18. Clevis pin 29. Adjustment clevis
8. Hex head flange 19. Strap 30. Clevis pin
9. Roll pin 20. Cap screw 31. Cotter pin
10. Brake arm 21. Flat washer 32. Brake lever
11. Left bearing bracket 22. Lever assembly
Most parking brake linkage parts can be repaired or re- IMPORTANT:Make sure to matchmark both parts
placed without removing any interference. However, the when removing the clevis from either the brake rod
right fender must be removed to work on the parking or brake lever or removing the brake lever from the
brake lever. cam shaft on the brake assembly, . Marking both
CAUTION
possible burns; allow engine and exhaust sys-
The muffler and exhaust pipe may be hot. Avoid
tem to cool before working near the muffler.
parts will make reassembly and brake adjustment
easier.
2. Remove and replace parts as necessary to repair
brake linkages (Fig. 12).
3. Reinstall right fender if necessary (see Right Fender
Installation).
1. Remove right fender if necessary (see Right Fender IMPORTANT:Always check and adjust the brakes
Removal). anytime brake linkages are disassembled or re-
paired (see Brake Adjustment).
Sand Pro 2020/3020/5020 Page 6 – 13 Wheels, Brakes,and Miscellaneous
Whells, Brakes,
and Miscellaneous