Toro Sand Pro 5020 - Manual (Page 162)

4. Position fork shaft up through frame. Install bearing
cone and bearing washer onto the shaft. If bearing con-
es were damaged, install new bearing cone onto shaft.
5. Screw slotted nut onto the fork shaft until a slight
drag is felt while rotating the fork. Back off nut so nearest
slot aligns with cross hole in the shaft. Secure nut to
shaft with cotter pin.
6. Install front wheel to the front fork (see Front Wheel
Installation).
7. Position steering chain around the sprocket and
chain guide. Secure chain to chain bracket with steering
adjustment pins and lock nuts. Adjust steering chain
(see Adjust Steering Chain).
Wheels, Brakes, and Miscellaneous Page 6 – 18 Sand Pro 2020/3020/5020