Toro Sand Pro 5020 - Manual (Page 37)

Muffler Installation
1. Position muffler through the bottom of the machine
to the muffler bracket. Insert cap screw with flat washer
through the muffler tab and then the muffler bracket.
Screw hex nut onto the cap screw, but do not tighten
(Fig. 30).
2. Attach exhaust tube to the muffler. Attach exhaust
tube to the exhaust manifold (Fig. 31).
3. Make sure exhaust tube fits snugly to both the muf-
fler and exhaust manifold. Secure exhaust tube to the
exhaust manifold and muffler with muffler clamps (Fig.
Figure 29
1
2
31).
1. Cap screw & star washer 2. Muffler shield
4. Tighten cap screw and hex nut securing the muffler
to the muffler bracket (Fig. 30).
5. Secure R–clamp and muffler shield to the engine
with three cap screws and star washers (Fig. 29).
6. Position traverse rod to the frame. Make sure each
side flange bearing is on the inside of the frame. Secure
bearings to the frame by tightening both hex flange head
screws on each bearing (Fig. 28).
7. Connect brake rod to the traverse rod lever. Secure
brake rod with cotter pin (Fig. 28).
8. Connect adjusting rods to both brake arms. Secure
both adjusting rods with a cotter pin (Fig. 27).
Figure 30
3
2
1
1. Lock nut & cap screw 3. Muffler bracket
9. Secure top of lift valve shroud, lift lever guide, and 2. Muffler
lift lever latch to the frame with both cap screws and lock
nuts. Make sure nylon lift lever guide is placed on top of
metal lift lever latch (Fig. 26).
10. Secure bottom of shroud to frame with cap screw.
Screw knob onto lift lever (Fig. 26).
11. Lower rear wheels to the ground after removing
blocks.
3
1
1
2
Figure 31
1. Muffler clamps 3. Muffler
2. Exhaust tube
Engine
Sand Pro 2020/3020/5020 Page 3 – 17 Engine