TANDBERG Codec C90 D14128.02 - Manual (Page 108)

D14128.02—NOVEMBER 2008 108
Codec C90 System Integrator Guide
Contents Introduction Getting Started Interfaces About the API xConfiguration xCommand xStatus Cameras Appendices Contact us Cameras
Best view—Face recognition
This camera is capable of face recognition when used with
TANDBERG C90 Codecs. Consequently, the functionality is subject
to change without further notice in order to take advantage of further
developments.
NOTE: Observe that the Best view feature is still a preview feature.
The face recognition system aims to search for faces in order to
optimize the picture frame, hence the name Best view. Once a face
or group of faces has been detected camera zoom and camera angle
will be changed accordingly to obtain an optimal presentation on the
screen.
Kindly observe the following:
The • Best view optimization process may take up to 5 seconds.
The detection of faces works better when people look towards the •
camera.
The area from the eyebrows down to just below the lips should be
•
uncovered.
Beard is normally not a problem.
•
Using Best view
Note that Best view works with TANDBERG C90 Codecs only!
Press the 1. Layout key on the remote control to display the
Layout menu. Select Selfview to be shown as required.
Press the 2. Home key on the remote control to display the
Home menu and select Camera control
In the Camera control menu, locate the 3. Best view button at the
bottom of the screen.
Press the corresponding 4. Soft key on the remote control to start
the Best view optimization process. Look towards the camera for
about five seconds.
The system will now look for human faces and adjust the zoom 5.
and camera angle to obtain a best fit.
4
7
ghi
pqrs
6
# abc/123
9
1 . @
5
0
8
jkl
tuv
2 abc 3 def
mno
wxyz
Press the corresponding
Soft key to start the Best
view optimization process.
Best view (beta) Exit
The Best view feature is found
in the Camera control menu.