TANDBERG Codec C90 D14128.02 - Manual (Page 42)

D14128.02—NOVEMBER 2008 42
Codec C90 System Integrator Guide
Contents Introduction Getting Started Interfaces About the API xConfiguration xCommand xStatus Cameras Appendices Contact us About the API
xCommand ?
– User Commands –
OK
About xCommand
xCommand type commands instructs the system to perform an
action. xCommand type commands are supplied by the user.
To get an overview of the supported xCommand type commands,
type
? or help after the xCommand:
xCommand ? •
xCommand help •
To get an overview of all supported xCommand commands with the
corresponding value space, enter
?? after the xCommand:
xCommand ?? •
When you type a command and ? or help a list of the available
parameters will show. Required parameters are identified by an ( r )
behind the parameter name.
Example:
xCommand Camera Ramp
- the result may look like this:
*h xCommand Camera Ramp
CameraId(r): <1..7>
Pan: <Left/Right/Stop>
PanSpeed: <1..15>
Tilt: <Down/Stop/Up>
TiltSpeed: <1..15>
Zoom: <In/Out/Stop>
ZoomSpeed: <1..15>
Focus: <Far/Near/Stop>
xCommand ??
*h xCommand Audio Microphones Mute
*h xCommand Audio Microphones Unmute
*h xCommand Audio LocalInput Update
InputId(r): <0..65534>
MixerMode: <Auto/Fixed>
AGC: <On/Off>
Mute: <On/Off>
Channels: <1..2>
*h xCommand Audio RemoteInput Update
InputId(r): <0..65534>
AGC(r): <On/Off>
*h xCommand Audio Sound Play
Sound(r): <Busy/CallWaiting/KeyTone/Ringing/SpecialInfo/TelephoneCall/VideoCall>
Loop: <On/Off>
*h xCommand Audio Sound Stop
*h xCommand Boot
.
.
.
OK
A return result parameter
The command type
The path
Required ( r ) parameter
A list of returned parameters
Audio
Boot
Call
CallLog
Camera
Dial
DTMF FarEndControl
HTTPFeedback
Key
Presentation
Preset
TStringSend
SStringSend Standby
Video
CamCtrlPip
SystemUnit
Phonebook
Experimental