TANDBERG Codec C90 D14128.02 - Manual (Page 78)

D14128.02—NOVEMBER 2008 78
Codec C90 System Integrator Guide
Contents Introduction Getting Started Interfaces About the API xConfiguration xCommand xStatus Cameras Appendices Contact us xCommand
xCommand SStringSend
Used to send data to far end, e.g. for control systems. Uses the H.224 data channel (UDP).
Required parameters with ( r ):
Message( r ): <S: 1, 256>
CallId: <0..65534>
Example:
xCommand SStringSend CallId:4 Message:”This is a test”
*r SStringSendResult (status=OK):
*r/end
OK
xCommand Standby Activate
Set system in standby mode.
Example:
xCommand Standby Activate
*r ActivateResult (status=OK):
*r/end
OK
xCommand Standby Deactivate
Bring system out of standby mode.
Example:
xCommand Standby Deactivate
*r DeactivateResult (status=OK):
*r/end
OK
xCommand Standby ResetTimer
System will enter standby mode after time specified by Delay parameter.
Required parameters with ( r ):
Delay: <1..480>
Example:
xCommand Standby ResetTimer Delay:10
*r ResetResult (status=OK):
*r/end
OK
The SString Send command The Standby commands