TANDBERG Codec C90 D14128.02 - Manual (Page 76)

D14128.02—NOVEMBER 2008 76
Codec C90 System Integrator Guide
Contents Introduction Getting Started Interfaces About the API xConfiguration xCommand xStatus Cameras Appendices Contact us xCommand
xCommand Key Release
Command used to emulate release an already pressed key on the remote control. The Key Release
command should be preceded by a Key Press command to emulate pressing the key.
Required parameters with ( r ):
Key( r ): <0/1/2/3/4/5/6/7/8/9/C/Call/Disconnect/Down/F1/F2/F3/F4/F5/Grab/Home/
Layout/Left/Mute/MuteMic/Ok/PhoneBook/Presentation/Right/Selfview/
Square/SrcAux/SrcCamera/SrcDocCam/SrcPc/SrcVcr/Star/Up/VolumeDown/
VolumeUp/ZoomIn/ZoomOut>\nExample:
xCommand Key Release Key:Home
*r KeyReleaseResult (status=OK):
*r/end
OK
xCommand Presentation Start
Will open dual presentation stream using selected presentation source when in call (if presenter option is
installed). When not in call, the selected presentation source will be displayed.
Required parameters with ( r ):
PresentationSource: <1..5>
Example:
xCommand Presentation Start PresentationSource:2
OK
*r PresentationStartResult (status=OK):
*r/end
xCommand Presentation Stop
Will stop dual presentation stream when in call. Will stop displaying presentation source locally when not in
call.
Example:
xCommand Presentation Stop
OK
*r PresentationStopResult (status=OK):
*r/end
The Presentation commands