TANDBERG Codec C90 D14128.02 - Manual (Page 80)

D14128.02—NOVEMBER 2008 80
Codec C90 System Integrator Guide
Contents Introduction Getting Started Interfaces About the API xConfiguration xCommand xStatus Cameras Appendices Contact us xCommand
xCommand SystemUnit OptionKey Add
Add option key to add extra system capabilities, e.g. Multisite.
Required parameters with ( r ):
Key( r ): <S: 16, 24>
Example:
xCommand SystemUnit OptionKey Add Key:******************
*r OptionKeyResult (status=OK):
*r/end
OK
xCommand SystemUnit ReleaseKey Add
Add software release key. Used to enable new software (applicable for main sw releases).
Required parameters with ( r ):
Key( r ): <S: 16, 24>
Example:
xCommand SystemUnit ReleaseKey Add Key:******************
*r ReleaseKeyResult (status=OK):
*r/end
xCommand SystemUnit AdminPassword Set
Set administrator password.
Required parameters with ( r ):
Password( r ): <S: 0, 255>
Example:
xCommand SystemUnit AdminPassword Set Password:***********
*r AdminPasswordSetResult (status=OK):
*r/end
OK
xCommand SystemUnit MenuPassword Set
Set password needed to access advanced menu settings.
Required parameters with ( r ):
Password( r ): <S: 0, 255>
Example:
xCommand SystemUnit MenuPassword Set Password:***********
*r MenuPasswordSetResult (status=OK):
*r/end
OK
The System Unit commands