TANDBERG Codec C90 D14128.02 - Manual (Page 64)

D14128.02—NOVEMBER 2008 64
Codec C90 System Integrator Guide
Contents Introduction Getting Started Interfaces About the API xConfiguration xCommand xStatus Cameras Appendices Contact us xCommand
xCommand type commands
In this chapter...
Audio commands
Boot command
Call commands
CallLog commands
Camera commands
Dial command
DTMF command
FarEndControl commands
HTTPFeedback commands
Key commands
Presentation commands
Preset commands
TStringSend, SStringSend
Standby commands
Video commands
CamCtrlPip commands
SystemUnit commands
Phonebook commands
Experimental commands
Chapter 6
Command type commands are used to
instruct the system to perform a given
action. Examples: place a call, mute
microphones, disconnect a call and more.
The command type is followed by a set of
parameters to specify how the given action
is to be executed.
NOTE: The description of the xCommand
commands are preliminary, and subject to
change.