TANDBERG Codec C90 D14128.02 - Manual (Page 41)

D14128.02—NOVEMBER 2008 41
Codec C90 System Integrator Guide
Contents Introduction Getting Started Interfaces About the API xConfiguration xCommand xStatus Cameras Appendices Contact us About the API
Example with xConfiguration Help:
To get help on xConfiguration, type
? or help after the configuration path (address expression):
xConfiguration <address expression> ?
xConfiguration H323 Profile 1 Gatekeeper Discovery ?
*h xConfiguration H323 Profile 1 Gatekeeper Discovery: <Manual/Auto>
OK
xConfiguration operations
Configuration type commands defines system
settings and are either supplied or read by the user.
Return result parameters
Three operations can be performed on
xConfiguration:
Configuration Help
Help text for this configuration is returned •
Configuration Read
*c • is used when returning the result of a read
query
Configuration Write
No return result parameter for configuration set •
(write)
xConfiguration Help
To get help on a system setting you can use a help
query. Enter the path followed by ? or help.
xConfiguration H323 Profile 1 •
Gatekeeper ?
Returns information about the setting defined
by the path.
xConfiguration H323 Profile 1
•
Gatekeeper help
As above.
xConfiguration Read
When reading a value you will use the configuration
read. The level of details is defined by the path:
xConfiguration H323 Profile 1 •
Gatekeeper Discovery
Returns the current value of the setting defined
by the path.
xConfiguration Write
When defining a system setting you will use the
configuration write. The structure is described by
the example to the right.
xConfiguration H323 Profile 1 •
Gatekeeper Discovery: Auto
Writes this value to the setting defined by the
path.
Example with xConfiguration Read:
To read configurations from the system just type the root command (xConfiguration) followed by the path
(address expression):
xConfiguration <address expression>
xConfiguration H323 Profile 1 Gatekeeper Discovery
*c xConfiguration H323 Profile 1 Gatekeeper Discovery: Manual
OK
Example with xConfiguration Write:
To issue a command type a root command (xConfiguration) followed by a valid path (address expression).
The path must be terminated with a colon before the value is added:
xConfiguration <address expression>: <value>
xConfiguration H323 Profile 1 Gatekeeper Discovery: Auto