ZyXEL Communications ZyXEL ZyWALL 2WG - Manual (Page 354)

Chapter 19 Policy Route
ZyWALL 2WG User’s Guide
354
Gateway Select User-Defined and enter the IP address of the gateway if you want to
specify the IP address of the gateway. The gateway is an immediate neighbor of
your ZyWALL that will forward the packet to the destination. The gateway must be
a router on the same segment as your ZyWALL's LAN or WAN interface.
Select WAN Interface to have the ZyWALL send traffic that matches the policy
route through a specific WAN interface. Select the WAN interface from the drop-
down list box.
Select the Use another interface when the specified WAN interface is not
available. check box to have the ZyWALL send traffic that matches the policy
route through the other WAN interface if it cannot send the traffic through the WAN
interface you selected. This option is only available when you select WAN
Interface.
Converted Type
of Service
Set the new TOS value of the outgoing packet. Prioritize incoming network traffic
by choosing Don’t Change, Normal, Min Delay, Max Thruput, Max Reliable or
Min Cost.
Converted
Precedence
Set the new outgoing packet precedence value. Values are 0 to 7 or Don’t
Change.
Log Select Yes from the drop-down list box to make an entry in the system log when a
policy is executed.
Apply Click Apply to save your changes back to the ZyWALL.
Cancel Click Cancel to exit this screen without saving.
Table 120 ADVANCED > POLICY ROUTE > Edit (continued)
LABEL DESCRIPTION