ZyXEL Communications ZyXEL ZyWALL 2WG - Manual (Page 539)

Chapter 37 Network Address Translation (NAT)
ZyWALL 2WG User’s Guide
539
"
You must press [ENTER] at the bottom of the screen to save the whole set.
You must do this again if you make any changes to the set – including deleting
a rule. No changes to the set take place until this action is taken.
Selecting Edit in the Action field and then selecting a rule brings up the following menu,
Menu 15.1.1.1
- Address Mapping Rule in which you can edit an individual rule and
configure the Type, Local and Global Start/End IPs.
"
An IP End address must be numerically greater than its corresponding IP Start
address.
Figure 326 Menu 15.1.1.1: Editing/Configuring an Individual Rule in a Set
Action The default is Edit. Edit means you want to edit a selected rule (see following field). Insert
Before means to insert a rule before the rule selected. The rules after the selected rule will
then be moved down by one rule. Delete means to delete the selected rule and then all
the rules after the selected one will be advanced one rule. None disables the Select Rule
item.
Select
Rule
When you choose Edit, Insert Before or Delete in the previous field the cursor jumps to
this field to allow you to select the rule to apply the action in question.
Table 219 Fields in Menu 15.1.1 (continued)
FIELD DESCRIPTION
Menu 15.1.1.1 Address Mapping Rule
Type= One-to-One
Local IP:
Start=
End = N/A
Global IP:
Start=
End = N/A
Server Mapping Set= N/A
Press ENTER to Confirm or ESC to Cancel: