ZyXEL Communications ZyXEL ZyWALL 2WG - Manual (Page 406)

Chapter 23 UPnP
ZyWALL 2WG User’s Guide
406
When a UPnP device joins a network, it announces its presence with a multicast message. For
security reasons, the ZyWALL allows multicast messages on the LAN only.
All UPnP-enabled devices may communicate freely with each other without additional
configuration. Disable UPnP if this is not your intention.
23.1.4 UPnP and ZyXEL
ZyXEL has achieved UPnP certification from the Universal Plug and Play Forum UPnP™
Implementers Corp. (UIC). ZyXEL's UPnP implementation supports IGD 1.0 (Internet
Gateway Device).
See the following sections for examples of installing and using UPnP.
23.2 Configuring UPnP
Click ADVANCED > UPnP to display the UPnP screen.
Figure 239 ADVANCED > UPnP
The following table describes the fields in this screen.
Table 147 ADVANCED > UPnP
LABEL DESCRIPTION
UPnP Setup
Device Name This identifies the ZyXEL device in UPnP applications.
Enable the Universal
Plug and Play (UPnP)
feature
Select this check box to activate UPnP. Be aware that anyone could use a
UPnP application to open the web configurator's login screen without
entering the ZyWALL's IP address (although you must still enter the
password to access the web configurator).
Allow users to make
configuration
changes through
UPnP
Select this check box to allow UPnP-enabled applications to automatically
configure the ZyWALL so that they can communicate through the ZyWALL,
for example by using NAT traversal, UPnP applications automatically
reserve a NAT forwarding port in order to communicate with another UPnP
enabled device; this eliminates the need to manually configure port
forwarding for the UPnP enabled application.