Figure 28 vpn wizard: gateway setting, Table 16 vpn wizard: gateway setting – ZyXEL Communications ZyXEL ZyWALL 2WG User Manual
Page 85
Chapter 3 Wizard Setup
ZyWALL 2WG User’s Guide
85
Figure 28 VPN Wizard: Gateway Setting
The following table describes the labels in this screen.
Table 16 VPN Wizard: Gateway Setting
LABEL
DESCRIPTION
Gateway Policy
Property
Name
Type up to 32 characters to identify this VPN gateway policy. You may use any
character, including spaces, but the ZyWALL drops trailing spaces.
My ZyWALL
When the ZyWALL is in router mode, enter the WAN IP address or the domain name
of your ZyWALL or leave the field set to 0.0.0.0.
The following applies if the My ZyWALL field is configured as 0.0.0.0:
When the WAN interface operation mode is set to Active/Passive, the ZyWALL uses
the IP address (static or dynamic) of the WAN interface that is in use.
When the WAN interface operation mode is set to Active/Active, the ZyWALL uses
the IP address (static or dynamic) of the primary (highest priority) WAN interface to
set up the VPN tunnel as long as the corresponding WAN1 or WAN2 connection is
up. If the corresponding WAN1 or WAN2 connection goes down, the ZyWALL uses
the IP address of the other WAN interface.
If both WAN connections go down, the ZyWALL uses the dial backup IP address for
the VPN tunnel when using dial backup or the LAN IP address when using traffic
redirect. See the chapter on WAN for details on dial backup and traffic redirect.
When the ZyWALL is in bridge mode, this field is read-only and displays the
ZyWALL’s IP address.
Remote
Gateway
Address
Enter the WAN IP address or domain name of the remote IPSec router (secure
gateway) in the field below to identify the remote IPSec router by its IP address or a
domain name. Set this field to 0.0.0.0 if the remote IPSec router has a dynamic WAN
IP address.
Back
Click Back to return to the previous screen.
Next
Click Next to continue.