ZyXEL Communications ZyXEL ZyWALL 2WG - Manual (Page 703)

Appendix I Command Interpreter
ZyWALL 2WG User’s Guide
703
Log Command Example
This example shows how to set the ZyWALL to record the access logs and alerts and then
view the results.
Routing Command
Use this command to set the ZyWALL to route traffic that does not match a NAT rule through
a specific interface. An example of when you may want to use this is if you have servers with
public IP addresses connected to the LAN, DMZ or WLAN. By default the ZyWALL routes
traffic that does not match a NAT rule out through the DMZ interface.
The following command example sets the ZyWALL to route traffic that does not match a
NAT rule through the WLAN interface.
ras> sys logs load
ras> sys logs category access 3
ras> sys logs save
ras> sys logs display access
# .time source destination notes
message
0|06/08/2004 05:58:21 |172.21.4.154 |224.0.1.24 |ACCESS
BLOCK
Firewall default policy: IGMP (W to W/ZW)
1|06/08/2004 05:58:20 |172.21.3.56 |239.255.255.250 |ACCESS
BLOCK
Firewall default policy: IGMP (W to W/ZW)
2|06/08/2004 05:58:20 |172.21.0.2 |239.255.255.254 |ACCESS
BLOCK
Firewall default policy: IGMP (W to W/ZW)
3|06/08/2004 05:58:20 |172.21.3.191 |224.0.1.22 |ACCESS
BLOCK
Firewall default policy: IGMP (W to W/ZW)
4|06/08/2004 05:58:20 |172.21.0.254 |224.0.0.1 |ACCESS
BLOCK
Firewall default policy: IGMP (W to W/ZW)
5|06/08/2004 05:58:20 |172.21.4.187:137 |172.21.255.255:137 |ACCESS
BLOCK
Firewall default policy: UDP (W to W/ZW)
Syntax: ip nat routing [0:LAN|1:DMZ|2:WLAN] [0:no|1:yes]