ZyXEL Communications ZyXEL ZyAIR NWA-3500 - Manual (Page 202)

Chapter 16 VLAN
ZyXEL NWA-3500 User’s Guide
202
16.2.5 Second Rx VLAN ID Example
In this example, the ZyXEL Device is configured to tag packets from SSID01 with VLAN ID
1 and tag packets from SSID02 with VLAN ID 2. VLAN 1 and VLAN 2 have access to a
server, S, and the Internet, as shown in the following figure.
Figure 128 Second Rx VLAN ID Example
Packets sent from the server S back to the switch are tagged with a VLAN ID (incoming
VLAN ID). These incoming VLAN packets are forwarded to the ZyXEL Device. The ZyXEL
Device compares the VLAN ID in the packet header with each SSID’s configured VLAN ID
and second Rx VLAN ID settings.
In this example, SSID01’s second Rx VLAN ID is set to 2. All incoming packets tagged with
VLAN ID 2 are forwarded to SSID02, and also to SSID01. However, SSID02 has no second
Rx VLAN ID configured, and the ZyXEL Device forwards only packets tagged with VLAN
ID 2 to it.
16.2.5.1 Second Rx VLAN Setup Example
The following steps show you how to setup a second Rx VLAN ID on the ZyXEL Device.
1 Log into the Web Configurator.
2 Click VLAN > Wireless VLAN.
3 If VLAN is not already enabled, click Enable Virtual LAN and set up the Management
VLAN ID (see Section 16.2.3 on page 191 ).
"
If no devices are in the management VLAN, then no one will be able to access
the ZyXEL Device and you will have to restore the default configuration file.
4 Select the SSID profile you want to configure (SSID03 in this example), and enter the
VLAN ID number (between 1 and 4094).