ZyXEL Communications ZyXEL ZyAIR NWA-3500 User Manual
Page 76
Chapter 4 Tutorial
ZyXEL NWA-3500 User’s Guide
76
4.4.6 Checking your Settings and Testing the Configuration
Use the following sections to ensure that your wireless networks are set up correctly.
4.4.6.1 Checking Settings
Take the following steps to check that the ZyXEL Device is using the correct SSIDs, MAC
filters and layer-2 isolation profiles.
1 Click WIRELESS > Wireless. Check that the Operating Mode is MBSSID and that
the correct SSID profiles are selected and activated, as shown in the following figure.
Figure 41 Tutorial: SSID Profiles Activated
2 Next, click the SSID tab. Check that each configured SSID profile uses the correct
Security, Layer-2 Isolation and MAC Filter profiles, as shown in the following figure.
Figure 42 Tutorial: SSID Tab Correct Settings
V
If the settings are not as shown, follow the steps in the relevant section of this
tutorial again.
4.4.6.2 Testing the Configuration
Before you allow employees to use the network, you need to thoroughly test whether the setup
behaves as it should. Take the following steps to do this.
1 Test the SERVER_1 network.