ZyXEL Communications ZyXEL ZyAIR NWA-3500 User Manual
Page 41
Chapter 1 Introducing the ZyXEL Device
ZyXEL NWA-3500 User’s Guide
41
2
WDS/SYS
Green
On
The ZyXEL Device is in AP+Bridge or Bridge/Repeater
mode, and has successfully established a Wireless
Distribution System (WDS) connection.
Red
Flashing
The ZyXEL Device is starting up.
Off
Either
•
The ZyXEL Device is in Access Point or MBSSID
mode and is functioning normally.
•
The ZyXEL Device is in AP+Bridge or Bridge/
Repeater mode and has not established a Wireless
Distribution System (WDS) connection.
or
•
The ZyXEL Device is not receiving power.
3
WL2
Green
On
The wireless adaptor WLAN2 is active.
Blinking
The wireless adaptor WLAN2 is active, and transmitting
or receiving data.
Off
The wireless adaptor WLAN2 is not active.
4
ZyAIR
Blue
On
The ZyXEL Device is receiving power.
You can turn the ZyAIR LED off and on using the Web
configurator. See
Blinking
The ZyXEL Device is receiving power and transmitting
data to or receiving data from its wireless stations.
Off
Either
•
The ZyXEL Device is not receiving power.
or
•
The ZyAIR LED has been disabled. See
for how to enable the ZyAIR LED.
5
ETHERNET
Green
On
The ZyXEL Device has a 10 Mbps Ethernet connection.
Blinking
The ZyXEL Device has a 10 Mbps Ethernet connection
and is sending or receiving data.
Yellow
On
The ZyXEL Device has a 100 Mbps Ethernet
connection.
Blinking
The ZyXEL Device has a 100 Mbps Ethernet connection
and is sending/receiving data.
Off
The ZyXEL Device does not have an Ethernet
connection.
Table 1 LEDs (continued)
LABEL
LED
COLOR
STATUS
DESCRIPTION