Xerox 7245 - Manual (Page 10)

10
Network Connectivity
Installation Steps
A1
Step 1. Connect one end of a Category 5 twisted pair cable to a live network drop. Connect the opposite
end of the cable to the RJ-45 socket at the rear of the Device.
Step 2. Set the Device's power switch to ON and wait until the Main screen is displayed.
Note: The actual screen displayed as the Main screen is selectable. To determine the screen you
would like displayed, press the Log In / Out button, enter the Administrator password (default of 11111),
press System Settings, press System Settings again. Press Common Settings, press Screen/Button
Settings, select Features Screen Default, touch Change Settings, make your selection and touch Save.
Touch Close repeatedly, until Exit is displayed in the upper right corner of your screen, then touch Exit.
Step 3. Refer to the Settings List topic in this guide and print a Settings List using the instructions
supplied.
All Services
Log In / Out
Machine Status