Garmin G1000 Socata TBM 850 - Manual (Page 138)

190-00709-01 Rev. A Garmin G1000 Pilot’s Guide for the Socata TBM 850 126
AUDIO PANEL AND CNS
SY
STEM
O
VER
VIEW
FLIGHT
INSTRUMENTS
EAS
AUDIO P
ANEL
& CNS
FLIGHT
MANA
GEMENT
HAZARD
AV
OID
ANCE
AFCS
ADDITIONAL FEA
TURES
APPENDICES
INDEX
ADF TUNING
ADF frequencies in the 190.0-kHz to 1799.5-kHz range are entered in the standby ADF frequency field of the
ADF/DME Tuning Window. The G1000 System does not tune the ADF emergency frequency, 2182.0-kHz.
Tuning an ADF frequency:
1) Press the ADF/DME Softkey to display the ADF/DME Tuning Window.
2) Turn the large FMS Knob to place the selection cursor over the standby ADF frequency field.
3) Turn the small FMS Knob to begin data entry and change each digit.
4) Turn the large FMS Knob to move the cursor to the next digit position.
5) Press the ENT Key to complete data entry for the standby frequency.
Figure 4-30 Entering ADF Standby Frequencies
Press the
ENT Key to
Complete ADF
Frequency Entry
Turn the Small
FMS Knob to
Enter Data in
the Standby ADF
Frequency Field
Turn the Large
FMS Knob
to Move the
Cursor to the
Next Character
Pressing the CLR Key before completing frequency entry cancels the frequency change and reverts back to
the previously entered frequency.
Pressing the CLR Key when the cursor is flashing, clears the frequency and replaces the standby field with
‘0000.0’.
Transferring the active and standby ADF frequencies:
1) Turn the large FMS Knob to place the selection cursor over the standby ADF frequency field.
2) Press the ENT Key to complete the frequency transfer.
Figure 4-31 Transferring ADF Frequencies
Press the ENT
Key to Transfer
the ADF
Frequencies