Garmin G1000 Socata TBM 850 - Manual (Page 265)

190-00709-01 Rev. A Garmin G1000 Pilot’s Guide for the Socata TBM 850 253
FLIGHT MANAGEMENT
SY
STEM
O
VER
VIEW
FLIGHT
INSTRUMENTS
EAS
AUDIO P
ANEL
& CNS
FLIGHT
MANA
GEMENT
HAZARD
AV
OID
ANCE
AFCS
ADDITIONAL
FEA
TURES
APPENDICES
INDEX
MISSED APPROACH
Activating a missed approach in the active flight plan:
1) Press the PROC Key.
2) Turn the FMS Knob to highlight ‘ACTIVATE MISSED APPROACH’.
3) Press the ENT Key. The aircraft automatically sequences to the MAHP.
COURSE TO ALTITUDE
In this missed approach procedure, the altitude immediately following the MAP (in this case ‘6368ft’) is not
part of the published procedure. It is simply a Course to Altitude (CA) leg which guides the aircraft along
the runway centerline until the required altitude required to safely make the first turn toward the MAHP
is exceeded. In this case, if the aircraft altitude is below the specified altitude (6,368 feet) after crossing
the MAP, a direct-to is established to provide a course on runway heading until an altitude of 6,368 feet
reached. After reaching 6,368 feet, a direct-to is established to the published MAHP (in this case MOGAL).
If the aircraft altitude is above the specified altitude after crossing the MAP, a direct-to is established to the
published fix (MOGAL) to begin the missed approach procedure. The altitude constraint value defaults to
400 feet AGL when there is no Course to Altitude defined in the published procedure.
In some missed approach procedures this Course to Altitude leg may be part of the published procedure.
For example, the procedure dictates a climb to 5,500 feet, then turn left and proceed to the Missed Approach
Hold Point (MAHP). In this case, The altitude would be labeled appear in the list of waypoints as ‘5500ft’.
Again, if the aircraft altitude is lower than the prescribed altitude, a direct-to is established on a Course to
Altitude leg when the missed approach procedure is activated.
Figure 5-94 Course to Altitude
Course to Altitude Leg