Garmin G1000 Socata TBM 850 - Manual (Page 34)

Garmin G1000 Pilot’s Guide for the Socata TBM 850 190-00709-01 Rev. A 22
SYSTEM OVERVIEW
SY
STEM
O
VER
VIEW
FLIGHT
INSTRUMENTS
EAS
AUDIO P
ANEL
& CNS
FLIGHT
MANA
GEMENT
HAZARD
AV
OID
ANCE
AFCS
ADDITIONAL FEA
TURES
APPENDICES
INDEX
OBS Selects OBS mode on the CDI when navigating by GPS (only
available with active leg)
CDI Cycles through GPS, VOR1, and VOR2 navigation modes on the
CDI
ADF/DME Displays the ADF/DME Tuning Window, allowing tuning of the
ADF, ADF Mode selection, ADF volume control, and selection of
the DME
XPDR Displays transponder mode selection softkeys
XPDR1 Selects the #1 transponder as active
XPDR2 Selects the #2 transponder as active
STBY Selects standby mode (transponder does not reply to any
interrogations)
ON Selects Mode A (transponder replies to interrogations)
ALT Selects Mode C – altitude reporting mode (transponder replies to
identification and altitude interrogations)
GND Manually selects Ground Mode, the transponder does not allow
Mode A and Mode C replies, but it does permit acquisition squit-
ter and replies to discretely addressed Mode S interrogations
VFR Automatically enters the VFR code (1200 in the U.S.A. only)
CODE Displays transponder code selection softkeys 0-7
0 — 7 Use numbers to enter code
BKSP Removes numbers entered, one at a time
IDENT Activates the Special Position Identification (SPI) pulse for 18
seconds, identifying the transponder return on the ATC screen
TMR/REF Displays Timer/References Window
NRST Displays Nearest Airports Window
MSG Displays Messages Window
Figure 1-16 Top Level PFD Softkeys