Engine & airframe systems, Generator speed gauge, Itt gauge – Garmin G1000 Socata TBM 850 User Manual

Page 99: Oil pressure and temperature gauges

Advertising
background image

190-00709-01 Rev. A

Garmin G1000 Pilot’s Guide for the Socata TBM 850

87

ENGINE & AIRFRAME SYSTEMS

SY

STEM

O

VER
VIEW

FLIGHT

INSTRUMENTS

EAS

AUDIO P

ANEL

& CNS

FLIGHT

MANA

GEMENT

HAZARD

AV

OID
ANCE

AFCS

ADDITIONAL

FEA
TURES

APPENDICES

INDEX

GENERATOR SPEED GAUGE

Generator speed is indicated as a percentage of maximum safe operating speed (rpm), from 0 to 120%. If

generator speed exceeds 104% a warning condition occurs.

Figure 3-7 Generator Speed Gauge

ITT GAUGE

The Interturbine Temperature (ITT) Gauge ranges differ for engine off/start and running conditions. Values

between 200 and 1200 degrees Celsius (°C) are shown at engine start; values change to 200 to 900°C when
the engine starts running. When the engine is not running, ‘OFF’ is annunciated above the ITT readout; this
changes to ‘STRT’ upon engine start. No annunciation is shown when the engine is running normally.

Figure 3-8 Interturbine Temperature Gauge Status Annunciations

Engine Start

Normal

Engine Off

Temperatures above which warnings occur are indicated by red tick marks along the ITT Gauge. Refer to

comments for the ‘ITT’ CAS message in Table 3-5 for warning issuance criteria.

OIL PRESSURE AND TEMPERATURE GAUGES

Engine oil pressure and temperature are shown along horizontal bar indicators below the engine gauges.

Oil pressure is shown in pounds per square inch (psi) and temperature in degrees Celsius (°C).

Figure 3-9 Oil Pressure and Temperature Gauges

Advertising