Grain Systems Unload Augers PNEG-1556 - Manual (Page 13)

3. Installation
PNEG-1556 8", 10" and 12" Commercial Vertical Drive Unit - Dual Drive 13
Attaching the Horizontal Flight (Continued)
C. Slide the flights into the unload tube. If necessary, reattach the unload flight to the center well.
D. Rotate the bearing plate until the head plate and the bearing plate holes align.
E. Reattach the horizontal bearing plate to the vertical auger with ONLY the UPPER and LOWER holes,
using the appropriate hex bolts and serrated flange nuts.
Installing the Motor Mount Adjuster
A. Place the motor mount adjuster between the back plate and the head plate on the cross-tube.
B. Insert the pivot rod through the back and head plates and the motor mount adjuster. Secure the pivot
rod in place with two (2) 3/16" x 2" cotter pins. (See Figure 3E below and Figure 3F on Page 14.)
Figure 3E
Bearing Plate Attachment Hardware Size
8" Four (4) 5/16" x 1" Grade 5 Hex Bolts and Serrated Flange Nuts
10" and 12" Four (4) 3/8" x 1" Grade 5 Hex Bolts and Serrated Flange Nuts