Grain Systems Unload Augers PNEG-1556 - Manual (Page 26)

3. Installation
26 PNEG-1556 8", 10" and 12" Commercial Vertical Drive Unit - Dual Drive
Installing the Belt Guard
A. With the belts properly tensioned, remove the bottom belt guard cover and slip the belt guard down
over the motor shaft and the flight pulley.
B. Bolt the belt guard to the belt guard mounting brackets using four (4) 3/8" x 1" flange bolts. The belt
guard mounting brackets should still be loose at this time.
C. Align the belt guard’s slot with the motor shaft and the flight drive shaft, making sure that the belt
guard does not come into contact with either of the pulleys. Tighten down the belt guard mounting
brackets to the bearing plate.
(See Figure 3R below and Figure 3S on Page 27.)
Figure 3R