Grain Systems Unload Augers PNEG-1556 - Manual (Page 28)

3. Installation
28 PNEG-1556 8", 10" and 12" Commercial Vertical Drive Unit - Dual Drive
Installing the Vertical Motor Cover
A. After both belt guards are installed, the vertical motor cover can be attached.
B. Use two (2) 1/2" x 1-1/4" flange bolts, through the holes on the vertical motor cover and attach them
to the 1/2" serrated flange nuts, in the slots at the top of the motor mount plate.
Figure 3T
C. Adjust the vertical motor cover up or down in the slots, making sure that there is adequate clearance
between the inside of the vertical motor cover and the top of the vertical motor housing.
D. After there is adequate clearance, tighten the flange bolts and serrated flange nuts.