Grain Systems Unload Augers PNEG-1556 - Manual (Page 24)

3. Installation
24 PNEG-1556 8", 10" and 12" Commercial Vertical Drive Unit - Dual Drive
Installing the Motor (Not Provided)
A. Attach the motor to the motor mount plate using appropriate bolts, lock washers and hex nuts.
(See Chart Below.)
Motor Bolt Selection
B. Install pulley onto motor shaft and make sure that it is aligned with the flight pulley. It may be necessary
to move spacers to gain shaft alignment. (See Figure 3P below and Figure 3Q on Page 25.)
Figure 3P
Motor Frame Hex Bolt Size Qty
56
5/16"-18 x 1-1/4" 4 143T
145T
182T
3/8"-16 x 1-1/4" 4
184T
213T
215T
254T
1/2"-13 x 1-3/4" 4
256T