Grain Systems Unload Augers PNEG-1556 - Manual (Page 32)

3. Installation
32 PNEG-1556 8", 10" and 12" Commercial Vertical Drive Unit - Dual Drive
Horizontal Drive
Vertical Drive
A. A magnetic starter should be used for the operator’s protection and for the protection of the motor.
This is to protect the operator against accidental restart caused by power interruption, conductor
fault, low voltage, circuit interruption or motor overload. Therefore, the motor must be restarted
manually. If using a motor with built-in thermal overload protection, make sure this type of motor has
a manual reset.
Auger Part #
Motor
Sheave
Size
Flight Sheave
NEMA Motor
Frame
Motor HP
Belt
Size
Belt
Quantity
Belt Type
Size RPM
8''
CE-00566
3.5'' 15'' 409
182T and 184T 3-5 HP 56 2
B
GK1346 213T and 215T 7-1/2 - 10 HP 57 3
10''
MHC00743
3.75'' 18.4" 357
184T 5 HP
65 2 BX
213T and 215T 7-1/2 - 10 HP
MHC00485 254T 15 HP 67 3 BX
12"
MHC00020
3.75'' 18.4" 357
213T and 215T 7-1/2 - 10 HP 68 2
BX
MHC00486 254T and 256T 15-20 HP 70 3
Auger Part #
Motor
Sheave
Size
Flight Sheave
NEMA Motor
Frame
Motor HP
Belt
Size
Belt
Quantity
Belt Type
Size RPM
8'' GK1346 5.0'' 15" 584 184T 5 HP 57 2 B
10'' GK4441 4.0'' 15" 467 213T 7-1/2 HP 59 3 B
12'' MHC01253 3.5'' 15" 409 215T 10 HP 62 3 BX
1750 RPM electric motors and controls shall be installed by a qualified
electrician and must meet the standards set by the National Electrical Code and
all local and state codes. Reset and motor starting controls shall be located
where the operator has unrestricted access to the controls.
Disconnect and lock out power before resetting motor overloads. Ensure
electric motors are grounded.