Installing the motor mount plate – Grain Systems Unload Augers PNEG-1556 User Manual
Page 16
Advertising
3. Installation
16
PNEG-1556 8", 10" and 12" Commercial Vertical Drive Unit - Dual Drive
Installing the Motor Mount Plate
A. Thread one of the motor mount adjustment nuts and one of the motor mount adjustment washers
approximately three-quarters (3/4) of the way down the motor mount adjuster’s threaded rod.
B. Once the nut and washer are in place, slip the motor mount plate over the adjuster and align the pivot
holes with the pivot tube.
and
Figure 3H
Advertising