Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-739 - Manual (Page 11)

PNEG-739 42" - 48" Platforms & Safety Cages 11
42'' Head Service Platform
1
Support Channels
Take time now and review all instructions and
drawings before attempting to assemble the plat-
form. Layout all parts for easy identification.
Determine if the shaft will extend to the left or
right hand side of the platform. The long side of
the support channels must extend to the shaft
side of the head. Start the head service platform
assembly by attaching two support channels to
the head platform brackets using 1/2" x 1" hex
bolts. (See Figure 1-1.)
FIGURE 1-1
For entire platform assembly, use carriage bolts
at slot-to-hole connections and hex head cap
screws at hole-to-hole connections.
HSP42010
(Installed)
Left Hand Deck
Channel Support
Bracket
HSP42032 (2)
Platform Support
Channel 120"
HSP42012 (1)
Platform Support
Channel
FIGURE 1-1