Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-739 - Manual (Page 26)

PNEG-739 42" - 48" Platforms & Safety Cages 26
48'' Head Service Platform
2
Assemble the deck hatch access door by
attaching the left and right hand hinges to bottom
side of the outside toeboard (HSP484117) using
5/16" x 1" hex bolts. Leave hardware loose until
the assembly is complete. Attach hatch assembly
(HSP484055) to the hinges and double nut the
hinge bolts. Do not over tighten.
Hatch Access Door
FIGURE 2-6
HSP484051 Two Rung Ladder
(See Note.)
HSP484117 Toeboard
Channel Assembly (38"-50")
HSP36003 Left Hand
Hatch Hinge
HSP36002 Right
Hand Hatch Hinge
HSP484055 Platform Hatch
BE-PLAT1 (2) Ladder
Standoff Angle
(See Note.)
Two Rung Ladder
Attach the ladder standoff angles as shown
below using 1/2" x 1" hex bolts. Then attach two
rung ladder to the standoff angles using
1/2" x 1" hex bolts. The top rung of the ladder
should be even with the top of the decking when
installed.Tighten all hardware. (See Figure 2-6)
BE-PLAT2 (2) Ladder
Standoff Angle
(See Note.)
NOTE: Only applicable for 38" - 72"
wide bucket elevators.