Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-739 - Manual (Page 24)

PNEG-739 42" - 48" Platforms & Safety Cages 24
48'' Head Service Platform
2
Bolt all handrail posts to the cross members and
Z board channels. Post that attach to cross mem-
bers will use 1/2" hardware, post that attach to
the Z board will use 3/8" hardware. Leave all
hardware loose until all posts and handrails are
in place. With all post in place attach hand rails
with 3/8" hardware. Review Figure 2-4 for proper
placement of post and handrails. HSP 484040
posts are attached to Z-board channel only.
Handrails and Handrail
Posts
HSP484045 (2) 60.250"
Handrail (38"-50")
HSP484041 (6) Handrail Angle (38"-50")
HSP484042 (2) 49.000"
Discharge Post (38"-50")
HSP484046 (2) 30"
Handrail (38"-50")
HSP484044 (4) Side Handrail (38"-50")
HSP482043 (2) End Handrail (26")
HSP484043 (2) End Handrail (38"-42")
HSP485043 (2) End Handrail (50")
HSP484040 (4) 42"
Angle Post (38"-50")
FIGURE 2-4 FIGURE 5-1