Grain Systems Custom, Utility and Bulk Tank Augers PNEG-1445 - Manual (Page 14)

14 PNEG-1445 6", 8", 10" and 12" Custom Augers
4. Assembly
Mounting Bearing to Bearing Plate (Continued)
Figure 4B
Installing Bearing Plate onto Tube
1. Align bearing with drive shaft and slip shaft through bearing.
2. Rotate plate until bolt holes in tube flange and plate align. Secure with appropriate bolts and
serrated flange nuts. (See Chart below.)
3. Only secure with UPPER and LOWER four (4) bolts. (See Figure 4C.) The other four (4) bolts will
be installed later with the belt guard mounting brackets. (See Chart below.)
NOTE: On the 10" and 12" systems use the four (4) 3/8"-16 x 1" bolts in this step, the longer bolts
will be used to attach the belt guard mounting brackets in a future step.
Figure 4C
Bearing Plate Bolts
6" and 8" 5/16"-18 x 1" Bolt
10" and 12" 3/8"-16 x 1" Bolt
( See Chart on Page 13 for bolt sizes.)
( See Chart above for bolt sizes.)
NOTE: Only the upper and lower
four (4) bolts are connected at
this point in the assembly.