Tightening the lock collar, Installing the motor (not provided) – Grain Systems Custom, Utility and Bulk Tank Augers PNEG-1445 User Manual
Page 18
18 PNEG-1445 6", 8", 10" and 12" Custom Augers
4. Assembly
Tightening the Lock Collar
1. Using a punch and hammer, drive the lock collar clockwise (the same direction as the shaft
rotation). Once the lock collar is set in place, use a hex head wrench to tighten the lock collar by
tightening the set screw.
NOTE: If the lock collar is not turned far enough, the set screw will not lock it into place.
Installing the Motor (Not Provided)
1. Attach the motor to the motor mount plate using appropriate bolts, lock washers, and hex nuts.
2. Install pulley onto motor shaft making sure that it is aligned with the flight pulley. It may be
necessary to move spacers to gain shaft alignment.
Figure 4J
Motor Bolt Chart
Motor Size
Hex Bolt Size
Qty
56
5/16"-18 x 1-1/4"
4
143T
145T
182T
3/8"-16 x 1-1/4"
4
184T
213T
215T
254T
1/2"-13 x 1-3/4"
4
256T