Installing the intake guard (continued) – Grain Systems Custom, Utility and Bulk Tank Augers PNEG-1445 User Manual
Page 26
Advertising
26 PNEG-1445 6", 8", 10" and 12" Custom Augers
4. Assembly
Installing the Intake Guard (Continued)
2. With the intake shaft inserted in the bushing make sure to leave approximately 1/2" of clearance
between the end of the flight and the face of the bushing.
Figure 4W
3. Attach the intake guard to the tube using the proper hex bolts and nylock nuts through the half
bands that are welded to the intake guard.
and
Figure 4X
Intake Guard Bolts
6"
5/16"-18 x 1-3/4" Grade 5 Hex Bolt
8"
5/16"-18 x 1-3/4" Grade 5 Hex Bolt
10"
3/8"-16 x 1-1/2" Grade 5 Hex Bolt
for bolt sizes.)
Advertising